Brushed DC Motor Driver with Integrated Current Regulation

Brushed DC Motor Driver with Integrated Current Regulation

The highly efficient DC brushed motor driver including an onboard shunt resistor for current regulation presented here is built using the DRV8251 chip. The operating supply voltage range of the project is 4.5V to 48V DC and the default output current capability is 2.1A. A trimmer...

Continue Reading
1.050
Views
0 Comments
Linear Actuator Controller with Limit Switch to prevent Overextension and Retraction

Linear Actuator Controller with Limit Switch to prevent Overextension and Retraction

The project described here is a very useful device for use with linear actuators. This controller prevents the actuator from reaching the physical movement limits of the actuator, thus it prevents burnout of motor and physical/mechanical damage to the actuator itself to the...

Continue Reading
1.127
Views
0 Comments
High-performance, High-reliability Bipolar Stepper Motor Driver

High-performance, High-reliability Bipolar Stepper Motor Driver

The project presented here is a bipolar stepper motor driver. It is based on BD63731EFV chip which is a low-consumption driver that is driven by a PWM signal. The power supply voltage of the project is 8 to 28V DC, and the rated output current is 3A. CLK-IN driving mode is adopted for...

Continue Reading
1.086
Views
0 Comments
3-Phase Brushless DC Sinusoidal Sensorless Fan Motor Driver

3-Phase Brushless DC Sinusoidal Sensorless Fan Motor Driver

Driving a low current 3 phase brushless Sensorless DC motor is very easy with this project. This Full-wave BLDC driver project is capable to drive low current brushless fan motor without a hall sensor. 180° sinusoidal drive, high torque output, and silent drive are a few key features...

Continue Reading
1.198
Views
1 Comments
PWM Temperature Controlled FAN using TC648 and NTC sensor

PWM Temperature Controlled FAN using TC648 and NTC sensor

The project described here is a switch mode fan speed controller for use with brushed or brushless DC motors. Temperature proportional speed control is accomplished using pulse width modulation (PWM). 10K Ohms NTC is used to sense the temperature. The project is built using TC648 chip...

Continue Reading
1.355
Views
0 Comments
DC Motor Controller using Relay and MOSFET – Arduino Interface

DC Motor Controller using Relay and MOSFET – Arduino Interface

The project presented here is a low-cost solution to control high power brushed DC motor speed and direction. Traditional DC motor controllers are based on solid-state circuitry known as H-Bridge. Here we have made an H-bridge configuration using high current 2 x relays which can...

Continue Reading
1.318
Views
0 Comments
Low-Cost DC Motor Direction Controller with Fast Brake using 2 Relays

Low-Cost DC Motor Direction Controller with Fast Brake using 2 Relays

The project presented here is a low-cost easy to use DC brushed motor direction controller with fast-brake, the project was built using two 12V Relays, 2 x BJT transistors, and 2 x tactile switches. The two LEDs are provided to display the motor direction, 2 tactile switch controls...

Continue Reading
1.182
Views
0 Comments
BLDC Motor and DC Brushed Motor Driver 

BLDC Motor and DC Brushed Motor Driver 

This BLDC motor driver board is equipped with a smart IFX007T half-bridge. The BLDC motor control project is capable to drive one BLDC motor. Alternatively, it can be used to drive one or two bi-directional DC motors (H-Bridge configuration, cascaded to support the second motor) or up...

Continue Reading
1.437
Views
0 Comments
Get new posts by email:
Get new posts by email:

Join 97,426 other subscribers

Archives